Many people don't know how to paste acrylic transparent board, so they spend money to install it. In fact, it is not difficult to paste a clean acrylic board, as long as we learn, we don't need to spend money to find someone to install it. So, how to paste acrylic transparent board?
1. Facade bonding: There are many bonding methods for transparent acrylic sheets, but the facade bonding technology is a very common method. Before applying glue, we need to wipe the surface clean and apply glue to improve the quality of the glue. We can stick with a mold to avoid shaking. If the thickness of the transparent acrylic sheet is less than 3mm, it can be directly injected into the syringe adhesive for bonding. If the thickness of the transparent acrylic sheet is greater than 3mm, the thin wire should be tempered first, and then the outer surface of the steel wire should be hardened, and then the joint should be completed under capillary action.
2. Butt joint method: Place two transparent acrylic plates horizontally on the operating table and close them, but leave a gap of 0.3 mm or less width with tape. Then, using a syringe, fill in the gap with glue until the tape is completely cured and torn.
3. Plane adhesive: This method becomes more specific. Firstly, the transparent acrylic sheet is cleaned by the surface of the adhesive. Then, when an appropriate amount of transparent acrylic sheet is applied, the work station is in contact with other transparent acrylic sheets by oblique pressure on the horizontal adhesive Paint transparent acrylic sheet, and then extrude and foam satisfactorily.
4. Cone bonding: This bonding method is acrylic transparent board, 90 degree angle mold bonding groove, so that the bonding surface does not move, gluing until fully cured, until the mold can be taken out, but slowly Slow but uniform.
