We are China’s top 3 plastic formwork factory, and we have been in plastic formwork field for years and we are equipped with 16 years' exporting experience and our plastic formwork had been sold to many more countries-USAn Canada, Mexico, Australia, NZ, UAE, Italy, Spain, Korea, Russia, Malaysia, Singapore, India, Thailand, Vietnam, South Africa, Ukraine, etc, and our quality, professional services and integrity bring us many more honored clients.
We are seated in Shandong Province and it takes 40 minutes to Jinan International Airport from our factory,approx 1hours from Beijing/Shanghai to Jinan International Airport.
Info for PP hollow formwork:
1. Dimensions: 4*8ft & 3*6 ft or bespoke size
2. Thickness: 10-25mm
3. Widely used colors: grey/white/black/grey+black color
4. Reused times:50+times
NOTE:
1. samples are available for quality checking and testing.
2. Formwork used construction work sites are available for inspection.
Strong points for our plastic formwork:
Light weight
Average weight 8.3kg/square meter ,make the work easily installation quickly ,save labor cost and shorten the period of project.
High strength,hardness,impact resistance-small check design
Small check design increase the strength , hardness and impact of resistance ,reduce the weight.Shore Hardness(HD) is 70 .Impact strength:Lateral pressure is 41.5KJ/m2, Vertical pressure is 85KJ/m2.
Easy demould and the best effect of casting molding
Smooth and clean surface make the de-mould easily .No need release agent ,only tapping then the formwork will fall off .And the effect of casting molding is very good .Also this finally shorten the period of project. The higher toughness Can be used to make other different shapes and size formwork. Bending strength:Lateral pressure 14Mpa, Vertical pressure 21Mpa .Bending modulus:Lateral pressure 782Mpa, Vertical pressure 970Mpa.
Waterproof-hollow design
Hollow design make the formwork panel structural stability .Dimensional shrinkage under heat:lateral 0.15% Vertical 0.13% .Difficult deformation, no mildew; Long-term immersion stratification in the water, no bubbles, sheet size stability, especially suitable for underground and damp environment.
Acid and alkali resistance, corrosion resistance
Very suitable for the engineering application in coastal areas, mine, as well
as seawall. It is need not do any preservative treatment both in using and
storing the formwork panels, which do not pollute the concrete surface.
Installation Instructions: let us take 15mm as the example:
1. Use the hollow building formwork intersecting laid with 15mm thick.
2.(1)Wood square of the distance on the surface of the intersection spacing
wood square distance according to the thickness of the slab concrete in
general the thickness of less than 0.15m floor spacing is 200~250m.
(2)The shear wall or sample using the formwork (15mm thickness spacing is
100~150mm if the shear wall pillar width more than 1 meter must add the fixed
frame.
3.Die shear wall and column puzzle when leaving no gaps internal angle the
bottom of the wall parts must have wood square beam wall formwork
connection shear wall made 4 after the mold must be assembled into the
whole hoisting then lay flat reduce labor intensity forming effect is good.
4.When the nail to the formwork from the formwork edge distance 15~30mm
strength wants moderate nail nails is 40~50mmm in length should not be too
long or too short.
5.Beam bottom of a piece of wood square must set aside 15 mm seam
allowance wallboard made on wood square seam allowance it does not leak slurry and wallboard material saving.
